The 1947 - Present Chevrolet & GMC Truck Message Board Network - Points to electronic ignition conversion

Page 2 of 2

Show 40 post(s) from this thread on one page

The 1947 - Present Chevrolet & GMC Truck Message Board Network (https://67-72chevytrucks.com/vboard/index.php)

- The 1967 - 1972 Chevrolet & GMC Pickups Message Board (https://67-72chevytrucks.com/vboard/forumdisplay.php?f=3)

- - Points to electronic ignition conversion (https://67-72chevytrucks.com/vboard/showthread.php?t=415550)

crazy longhorn

07-21-2011 11:50 PM

Re: Points to electronic ignition conversion

I cant help you with milege specs on this one.....but, I run a "flying magnet" pertronix conversion in my 383. She has an Accel Super coil, & I have seen the old gen I Chev twisted to 7200, without so much as a hiccop....crazyL

Mikey17

01-21-2012 11:10 PM

Re: Points to electronic ignition conversion

Hey everyone, I have a 67 c10 lwb and i recently did an Ignitor III conversion with the 45,000v .32ohm flamethrower coil. My truck wont start and im not very good in the wiring department. My battery died so i charged it up and everytime i turn my ign. switch to on or acc. my starter clicks. when i have it on start it turns over fine but no spark. anyone have any ideas?
thanks,
Mike
tryin to get back on the road quickly :O
:burnout:

All times are GMT -4. The time now is 01:28 PM.

Page 2 of 2

Show 40 post(s) from this thread on one page