![]() |
Re: 1990 K1500 xcab complete parts truck
It was worth the try, Thanks !
|
Re: 1990 K1500 xcab complete parts truck
Updating the "available list":
Drivers door $100 (complete with PW and PL) Tailgate $100 (complete) Engine 101k miles with serpentine and TBI setup $500 (no wiring or starter) Will seperate serpentine setup from motor, $200 complete. Split bench seats $200 (rear free for additional shipping) Putnam Class IV hitch $90 (used for 6 months) instument panel/gauges 101k miles $50 tilt column for AT $100 (no steering wheel) wiper motor $30 cruise servo w/cable $30 transfer case $80 (np241 for 700R4) front driveshaft $25 steering box $50 factory jack/tire tools and box $50 |
Re: 1990 K1500 xcab complete parts truck
How much for the whole lot if I came to pick it all up?
|
Re: 1990 K1500 xcab complete parts truck
how bout tag holder for front bumper,door seal on the drivers side.
|
Re: 1990 K1500 xcab complete parts truck
Quote:
|
Re: 1990 K1500 xcab complete parts truck
I need the fan off of the engine, without the clutch.
How much will you take for it? I'm at zip code 29112. Please e-mail me at dmoss69@yahoo.com thanks David Moss |
Re: 1990 K1500 xcab complete parts truck
The fan will be staying with the engine, or at lease the serpentine setup.
Thanks Quote:
|
Re: 1990 K1500 xcab complete parts truck
What kind of center caps does it have if they are the flat disc type and are for 6 lug I am interested.
PT |
Re: 1990 K1500 xcab complete parts truck
Quote:
|
Re: 1990 K1500 xcab complete parts truck
PM sent
|
Re: 1990 K1500 xcab complete parts truck
I am interested in the drivers door. Any chance of getting it shipped to Las Vegas 89143? If so, what kind of condition is it in?
|
Re: 1990 K1500 xcab complete parts truck
Quote:
Check www.car-part.com for a door closer to you. |
Re: 1990 K1500 xcab complete parts truck
Thought maybe you might know an inexpensive way to ship...That is a really good price compared to out here. It was worth a try anyways...Thanks for the link...Still looking. :)
|
Re: 1990 K1500 xcab complete parts truck
do you still have the tow hooks,if so pm me with price shipped to 67401,thanx.......mike
|
Re: 1990 K1500 xcab complete parts truck
I shipped a door UPS for 87.00 to GA. from TX.
|
Re: 1990 K1500 xcab complete parts truck
Quote:
How did you pack it? |
Re: 1990 K1500 xcab complete parts truck
Listen guys...do yourselves a huge favor and check out DHL. They let you ship pacjages up to 200 LBS!!. If you go to U-Haul and buy some of their TV boxes, you can make an oversize box from them to cover doors etc. I shipped a 60/40 bench seat using these boxes and it cost me $60.00 for both boxes. DHL does not care how big the boxes are in relation to weight. If you ship ground they are a 1/4 to 1/3 the price of UPS or Fed-Ex. Now go have fun and ship those things out already.!!
|
Re: 1990 K1500 xcab complete parts truck
Putnam Class IV hitch $90
do you have a pic? and Ship to 53530 |
Re: 1990 K1500 xcab complete parts truck
1 Attachment(s)
JDL,
Shipping for the hitch would run $18 by DHL. I dont have a picture handy, could get one this weekend. Attached is an advertising picture. Data on this hitch: Chevrolet 88-00 Long & Short Bed (with factory bumper) GMC 88-00 Long & Short Bed (with factory bumper) Weight Carrying 8,000lbs. With Weight Distribution 12,000lbs Approx Installation Time: 30 Minutes (no drill) I liked it because the main tube is hidden, all that sticks down is the receiver tube and the safety chain holes. That and most of the class III hitches are 6,000 pound rated which can easily be exceeded with a car trailer. |
Re: 1990 K1500 xcab complete parts truck
Ok are you in Rochester or just close to it. I think I can get a load to there
|
Re: 1990 K1500 xcab complete parts truck
A few sold's:
Hitch is sold Tow hooks are sold Wiper motor sold Thanks guys! Updating the "available list": Drivers door $100 (complete with PW and PL) Tailgate $100 (complete) Engine 101k miles with serpentine and TBI setup $500 (no wiring or starter) Will seperate serpentine setup from motor, $200 complete. Split bench seats $200 (rear free for additional shipping) instument panel/gauges 101k miles $50 tilt column for AT $100 (no steering wheel) cruise servo w/cable $30 transfer case $80 (np241 for 700R4) front driveshaft $25 steering box $50 factory jack/tire tools and box $50 |
Re: 1990 K1500 xcab complete parts truck
I got the hitch today and it looks all most new. Thanks
|
Re: 1990 K1500 xcab complete parts truck
Quote:
Thanks again! |
Re: 1990 K1500 xcab complete parts truck
Chris, got the wiper motor installed this weekend. Works like a charm.
|
Re: 1990 K1500 xcab complete parts truck
do you have the flywheel cover and arms and brackets under the motor mounts?
|
All times are GMT -4. The time now is 03:13 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com