Originally Posted by DLTruck1973 (Post 7020322)

I have to pull it and test it. I should have some others here also. If I have a working one it would be $25.00 plus the shipping. Get me a zip code if interested and I will quote it with shipping.

Thank you,
Thomas

Originally Posted by 63burban (Post 7016521)

I will take the heater control. 53035

Originally Posted by 77lesabre (Post 7026600)

Do you have a 2 piece driveshaft available?

Originally Posted by DLTruck1973 (Post 7026630)

I will need to know what wheel base, what engine/trans and what rear differential you are using to give you a yes or no. The truck here does not have a driveshaft but I have some others that may work.

Let me know and I will see what I can do to help you.

Thank you,
Thomas

Originally Posted by 77lesabre (Post 7026647)

I have a 61 long bed with a Chevy 350 and 700r4 tranny. I'm installin the porterbuilt dropmember and need to switch over to a 2 piece drive shaft. If there is one that will work without modifying then that would be awesome, but I figure I'll have to shorten/modify one with all of my mods so far.

Originally Posted by smackhead61 (Post 7021034)

How much would shipping be for the passenger door to 66216? I'd be interested in the bare door at 75.00 depending on shipping, Thanks.

Originally Posted by smackhead61 (Post 7026844)

We're you able to price the cost of shipping for the passenger door to 66216? Thanks

Originally Posted by 67chevy4x4c (Post 7026962)

Did you have the two speed wiper motor for the 62 truck?

Originally Posted by smackhead61 (Post 7026844)

We're you able to price the cost of shipping for the passenger door to 66216? Thanks

Originally Posted by DLTruck1973 (Post 7022126)

Price for the door panels shipped is $83.43. The box has to be rather big to ship these without damage.

Let me know and I will get them ready.

Thank you for the interest,
Thomas

Originally Posted by DLTruck1973 (Post 7016466)

Cig Lighter...$12.50 do not know if it works.
Switch Knobs... Wiper $7.50 / Head light...$7.50
Fender and door trim pieces... What is left of the trim is rough(dents and deep gouging in areas) but I can sell the left front fender piece for $10.00 and the small short piece on the pass door for $10.00.

I will need to pull everything and package it all up for a accurate shipping quote. With out the trim pieces, I could get the other parts in a small flat rate box for $5.25.

Let me know and thank you for the interest,
Thomas

Originally Posted by DLTruck1973 (Post 7027018)

Ok, I got the quote and you are looking at $165.55 for shipping plus $75.00 for the door for a total of $240.55.

Let me know and thank you for the interest,
Thomas

Originally Posted by DPowers (Post 7027160)

I can't tell if they are custom knobs or not?

Originally Posted by iceman777 (Post 7027509)

do you have the pump for the washer bottle and windshield squirters

Originally Posted by smackhead61 (Post 7027595)

Thanks for the quote. As much as I would like to have an original paint door I'm going to pass. Price for the door is outstanding, shipping price would kill me. Thanks for your assistance and good luck.

Steve

Originally Posted by 63burban (Post 7029057)

Heater control arrived in great condition, thanks much

Originally Posted by bhc41051 (Post 7034427)

Looking for 3 of these these little clips for the washer hose.