Re: GM connect and cruise engine package
 

One more

Re: GM connect and cruise engine package
 

Some more that got done.

Re: GM connect and cruise engine package
 

Some more pic

Re: GM connect and cruise engine package
 

Can't post but one pic at a time ?

Re: GM connect and cruise engine package
 

Made my on pedal bracket using the factory holes.

Re: GM connect and cruise engine package
 

My motor sets to high in the front. I have the CPP motor stands with dirty dingo sliders. I'm at 6 degrees with a degree finder on the top of the intake. What s up? Are any one else haveing the same trouble? I used the original trans cross member.

Re: GM connect and cruise engine package
 

How do I make this a build thread or link? Rename it or move it?

Re: GM connect and cruise engine package
 

Did you figure out the problem?

Re: GM connect and cruise engine package
 

Still have not found the fix to the exstream angle of motor. I can put a3/4 spacer under trans crossmember and get it to 5* but trans touches front of trans tunnel at pinch weld.

Re: GM connect and cruise engine package
 

Can the motor come forward then on its mounts so the back of the trans can come up more?

Re: GM connect and cruise engine package
 

Can't move forward,won't have room for air intake tube between motor and fans

Re: GM connect and cruise engine package
 

Ok up date on truck been a lot going on. Holley front drive installed air intake built brake lines made and run motor back in and now build a exhaust.

Re: GM connect and cruise engine package
 

How do u load more than one picture at a time?

Re: GM connect and cruise engine package
 

Whos top rad mount did you use ?

Re: GM connect and cruise engine package
 

Made my own. Trying to post pictures.

Re: GM connect and cruise engine package
 

Got pic to upload finally. Added this two sence last post. White 70 is a driver and the blue is work in progress.

Re: GM connect and cruise engine package
 

Pic. Upload

Re: GM connect and cruise engine package
 

Pic

Re: GM connect and cruise engine package
 

Pic.

Re: GM connect and cruise engine package
 

Pic.

Re: GM connect and cruise engine package
 

I wouldn't measure the angle on the top of the motor. You need the angle at the trans tail shaft. Then you match that angle at the rear end pinion. 3 degrees down and 3 degrees up is good. Often you have to tweek it after all the weight is on the wheels. You can do that on the trans crossmember or angled shims on the spring perches. If you draw an imaginary line back from the trans output shaft, and another line forward from the rear pinion, the two lines should be parallel. Google image driveline angles and get some good explanation.

Re: GM connect and cruise engine package
 

Re: GM connect and cruise engine package
 

At the crank front pulley I have 4*now. Thank I'll be good for now.

Re: GM connect and cruise engine package
 

Front pulley would work too. Good idea. Gonna have to remember that one.

Re: GM connect and cruise engine package
 

What r u guys doing for exhaust and what muffler?