|
Re: My 63 Project
1 Attachment(s)
One piece rear main.
|
Re: My 63 Project
1 Attachment(s)
Full roller 383 TJ.
|
Re: My 63 Project
Quote:
|
Re: My 63 Project
Quote:
|
Re: My 63 Project
Nice numbers on the engine and it looks great. Bet you can't wait to break it in...
|
Re: My 63 Project
Quote:
|
Re: My 63 Project
1 Attachment(s)
This appears to the extent of my rust repairs.
|
Re: My 63 Project
1 Attachment(s)
I have some holes to fill.
|
Re: My 63 Project
1 Attachment(s)
Little bit of welding, some plugs and a thin coat of Bondo.
|
Re: My 63 Project
1 Attachment(s)
Little bit of sanding.
|
Re: My 63 Project
1 Attachment(s)
Primer....
|
Re: My 63 Project
From one desert rat to another nice start to the build. Very clean truck, good find!
|
Re: My 63 Project
1 Attachment(s)
After spending so much time on the firewall, I pretty much made up my mind that I could spend MONTHS getting it perfect and realizing that I can't do that, I went ahead and cleaned it all up, primed it and painted it.
I suppose we all get to the point where we know we aren't making a Ridler.... So get it done and make it look good. |
Re: My 63 Project
1 Attachment(s)
Cross member getting ready to go back in.
|
Re: My 63 Project
1 Attachment(s)
Lower control arm on the passenger side done.
|
Re: My 63 Project
1 Attachment(s)
One full coil plus 2" in the drop spindles should bring the nose down some.
|
Re: My 63 Project
1 Attachment(s)
Springs, control arms and spindles all done.
|
Re: My 63 Project
Nice truck and cool project! I really should have bought a truck when I lived out west!
|
Re: My 63 Project
Sweet! looking good! Cutting or heating the coils always makes for a new stance! lol! :chevy:
|
Re: My 63 Project
1 Attachment(s)
Big motor, big brakes!
|
Re: My 63 Project
1 Attachment(s)
That was pretty easy. Hand packing wheel bearings is not so fun.
|
Re: My 63 Project
1 Attachment(s)
Just to make sure everything works. My thoughts on color for the calipers.... Red. Anyone else care to weigh in??
|
Re: My 63 Project
1 Attachment(s)
And then I got lucky, my after market wheels that I had been using with a roller, also are after market enough to handle the disk brakes.
I didn't think they were going to fit, which really would have caused some problems because I wouldn't be able to put it back together until I bought my final wheels. So now I can. Which is awesome!! |
Re: My 63 Project
1 Attachment(s)
So now that we have got her out of the clouds. And I think we will gain another inch or two when I put that motor back in.
|
Re: My 63 Project
Man that looks good! Nice set of discs ya have there! LOL! Big motor, Big brakes and BIG MONEY!!! HAHAHAHAHAHHAHA!!!!!;) MERRY CHRISTMAS!!!!!!!!!!!!!!:chevy:
|
| All times are GMT -4. The time now is 11:28 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com