The 1947 - Present Chevrolet & GMC Truck Message Board Network

The 1947 - Present Chevrolet & GMC Truck Message Board Network (https://67-72chevytrucks.com/vboard/index.php)
-   The 1967 - 1972 Chevrolet & GMC Pickups Message Board (https://67-72chevytrucks.com/vboard/forumdisplay.php?f=3)
-   -   What did you do to your truck today! (https://67-72chevytrucks.com/vboard/showthread.php?t=401176)

67chevy1series 01-15-2011 07:31 PM

Re: What did you do to your truck today!
 
Quote:

Originally Posted by 67Slider (Post 4413700)
Let's see it Rick. I have been thinking of picking one of these up. I am curious to how it looks.

Matt

here you go i would do it if i was you ! http://i1210.photobucket.com/albums/...g?t=1295132917 http://i1210.photobucket.com/albums/...g?t=1295132917 http://i1210.photobucket.com/albums/...g?t=1295132917
Quote:

Originally Posted by oldblue1968chevy (Post 4413713)
Attempted to fix my speedometer

Rick has pictuers of it in the build thread of his

yep i sure do!

Sonicman 01-15-2011 09:20 PM

Re: What did you do to your truck today!
 
Centered my steering wheel. It was off by a quarter turn. Then I replaced my left turn signal canceling spring. I was the guy whose left turn signal never gets turn off.

OG2wdblaze 01-15-2011 09:32 PM

Re: What did you do to your truck today!
 
drove it...for the first time in about eight years I took it for a drive!!! also did a little body work and started smoothing my top!

treeboy97 01-15-2011 09:47 PM

Re: What did you do to your truck today!
 
I removed my saginaw 4 speed and tried in install a T5. I ran into a small problem with the clutch disk, I had bought an 11 and actually need a 10 inch clutch disk. I will start over next Saturday!

alwaysbroken 01-15-2011 10:47 PM

Re: What did you do to your truck today!
 
put the motor, trans, and tcase in my 4x4 :chevy:

Navy Mechanic 01-15-2011 11:04 PM

Re: What did you do to your truck today!
 
4 Attachment(s)
Finished installing front drop springs, spindles, shocks, ball joints, tie rods, etc.

glider_6969 01-15-2011 11:13 PM

Re: What did you do to your truck today!
 
2 Attachment(s)
I pulled the seats out,, again, and put in the speaker and storage box I made and then put the seat back in,,, i probably should have wiped it down before I took the pics,:dohh:
Attachment 682750

Attachment 682751

jhwkns 01-16-2011 12:05 AM

Re: What did you do to your truck today!
 
Quote:

Originally Posted by og2wdblaze (Post 4413983)
drove it...for the first time in about eight years i took it for a drive!!! Also did a little body work and started smoothing my top!

wtg!

Bull72 01-16-2011 02:07 AM

Re: What did you do to your truck today!
 
got a new alternator today =) I really wanted a chrome one, but that will have to wait.

60ratrod 01-16-2011 02:44 AM

Re: What did you do to your truck today!
 
Quote:

Originally Posted by Bull72 (Post 4414726)
got a new alternator today =) I really wanted a chrome one, but that will have to wait.

i hear that the chrome ones have less of a life span since the chrome keeps the heat in more than the natural cast ones

Mike Bradbury 01-16-2011 02:47 AM

Re: What did you do to your truck today!
 
Polished some chrome and did a compression test on the engine. All came out at 149 almost exactly. But I am still blowing a little smoke out the passenger side pipe when I romp on it.

Bull72 01-16-2011 05:46 PM

Re: What did you do to your truck today!
 
Quote:

Originally Posted by 60ratrod (Post 4414791)
i hear that the chrome ones have less of a life span since the chrome keeps the heat in more than the natural cast ones

Well I am glad to hear that then =)

Sonicman 01-16-2011 07:20 PM

Re: What did you do to your truck today!
 
Put in headlight relays. I can't wait til it's dark to see the fruit of my labor!

FlounderGDI 01-16-2011 07:25 PM

Re: What did you do to your truck today!
 
4 Attachment(s)
I got the itch to work on the truck today so I braved the cold and bolted down my new bed mounted tool box... I also did some repair to my heater switch plug... Next up on the to-do list is to install my Skip White HEI... :metal:

project 67 sub 01-17-2011 02:48 AM

Re: What did you do to your truck today!
 
2 Attachment(s)
did a little more work on the replacement dash, wire wheeled the paint off, and cut out the radio hole. i offset the hole to the right because i am going to add a push button starter on the left side of it. i also might add a few other things as well but not sure yet, and i would have to figure out what exactly that would be first lol.
Attachment 683594

Attachment 683595

project 67 sub 01-17-2011 09:18 PM

Re: What did you do to your truck today!
 
4 Attachment(s)
not much of an update as of yet, but, just some messing around. took a pic of the current engine setup as i dont have a pic of that in here. i also pulled the springs out of the front to see how low it is. still need to finish the lower arms, and install bags and spindles, but i only have 3/4" before the arms hit the grond:devil::metal:
Attachment 683925

Attachment 683926

Attachment 683927

Attachment 683928

j_cst_10 01-17-2011 09:46 PM

Re: What did you do to your truck today!
 
I bumped into it with my 2002 Silverado while pulling into the driveway.

cobrajet21 01-17-2011 09:48 PM

Re: What did you do to your truck today!
 
have not touched it in a year.

project 67 sub 01-17-2011 09:48 PM

Re: What did you do to your truck today!
 
ouch! did it do any damage???

67Slider 01-17-2011 10:38 PM

Re: What did you do to your truck today!
 
Replaced inner and outer tie rod ends, upper and lower ball joints, and cut one coil out of the front springs. Tried my wipers and found that I had installed the linkage backwards. Had to take the cowl off and swap the pivot arm. Buttoned her back up and parked her in the garage. I had replaced my rear springs with Jeep TJ springs awhile back. I finally got around to measuring the drop and come to find out one side is 1.75 inches higher than the other. I guess I will fork out the 100 bucks for real drop springs. I should have known better but it sounded like a great deal(the TJ springs).

j_cst_10 01-17-2011 10:41 PM

Re: What did you do to your truck today!
 
No, not that I can tell. I really don't know how it didn't mess something up. It does have 4 inches of snow on it so who knows.

kpeztruck 01-17-2011 10:55 PM

Re: What did you do to your truck today!
 
Quote:

Originally Posted by magwakeenercew2jh (Post 4412236)
Yup. Kimber .45 CDP Ultra II.

Sold it yesterday.

Lookin' for wheels:

http://tinyurl.com/4qxg2tj

Must be a nice set of wheels you are hunting for, I still have my Kimber Compact 12 years later. Carry it everyday. Hate to see you have to part with such a nice handgun. Paul Baxter

trkfrk 01-18-2011 12:04 AM

Re: What did you do to your truck today!
 
Pulled engine/trans (mock-up) Prepped for powder coating. Cut 4" exhaust holes in frame. Sandblasted A-arms.

http://i806.photobucket.com/albums/y...mas2010093.jpg

http://i806.photobucket.com/albums/y...mas2010099.jpg

http://i806.photobucket.com/albums/y...mas2010096.jpg

bc gman 01-18-2011 12:05 AM

Re: What did you do to your truck today!
 
I put the first coat of teak oil/thinner on the red oak bedwood,just the start of many coats.

magwakeenercew2jh 01-18-2011 12:20 AM

Re: What did you do to your truck today!
 
Quote:

Originally Posted by kpeztruck (Post 4419429)
Must be a nice set of wheels you are hunting for, I still have my Kimber Compact 12 years later. Carry it everyday. Hate to see you have to part with such a nice handgun.

Thanks, Paul. I'm still covered. But that one was the most expensive I had. It took all of what I got for it for the Boss 338 20's. The "Little Woman" bought me tires for an early Valentine.


All times are GMT -4. The time now is 05:43 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com