The 1947 - Present Chevrolet & GMC Truck Message Board Network - What did you do to your truck today.The 3rd chapter

Page 62 of 197

Show 40 post(s) from this thread on one page

The 1947 - Present Chevrolet & GMC Truck Message Board Network (https://67-72chevytrucks.com/vboard/index.php)

- The 1967 - 1972 Chevrolet & GMC Pickups Message Board (https://67-72chevytrucks.com/vboard/forumdisplay.php?f=3)

- - What did you do to your truck today.The 3rd chapter (https://67-72chevytrucks.com/vboard/showthread.php?t=773345)

JMD	10-01-2020 06:25 PM

Re: What did you do to your truck today.The 3rd chapter

3 Attachment(s)

Ditched the in cab gas tank and went with something a little more EFI friendly.

cornerstone

10-01-2020 11:12 PM

Re: What did you do to your truck today.The 3rd chapter

Quote:

Originally Posted by JMD (Post 8816633)

Ditched the in cab gas tank and went with something a little more EFI friendly.

That's pretty trick! How many gallons can you hold? Nice and clean install in a beautiful truck.:chevy:

Ol Blue K20

10-02-2020 06:25 AM

Re: What did you do to your truck today.The 3rd chapter

Very nice, I'm also curious about the capacity too.

JMD	10-02-2020 07:38 AM

Re: What did you do to your truck today.The 3rd chapter

Thanks guys, it’s a 60gal tank so I have the sending unit read empty when there’s about 20 gallons remaining. Even though the tank is baffled the pump was still starving for fuel under hard acceleration and left hand turns. I might install a sump at some point but for now I’m just enjoying being able to drive more than 100 miles between fill ups.

ohboy321

10-02-2020 09:14 AM

Re: What did you do to your truck today.The 3rd chapter

Quote:

Originally Posted by 72c20customcamper (Post 8816343)

I'm going to have to rent one of these. Need to do the 68 and in the past I've used ezoff and just my garden hose. Worked well but I haven't been able to find any oven cleaner in several stores . They've been sold out for weeks guess there's been a rush on even cleaners too

Tried engine cleaner but it really didnt work at all. The gunk stuff they must have changed the formula

I use Gunk on some things, but always follow that with degeaser. With the hot pressure washer I just used degreaser. The wand was a bit long, but being a 4x4 I had enough room to maneuver underneath. The 200+ degree water with high psi did a nice job.

ohboy321

10-04-2020 12:35 PM

Re: What did you do to your truck today.The 3rd chapter

1 Attachment(s)

Removed my camshaft and lifters today. No mechanical issues found. It is a Gen I 5.3L 327ci that was rebuilt at some point. Next I will be replacing the valve springs and start cleaning it up for paint.

89AKurt

10-04-2020 04:00 PM

Re: What did you do to your truck today.The 3rd chapter

For someone mechanically challenged like me, adding the legal license plate light was a cinch! (previous owner put new bumpers on, but not this) And it worked first time! :lol:
https://live.staticflickr.com/65535/...1c279f30_c.jpg

72c20customcamper

10-04-2020 04:04 PM

Re: What did you do to your truck today.The 3rd chapter

2 Attachment(s)

Made it work for it keep. Not hard but enough

Astro-Balls

10-04-2020 06:46 PM

Re: What did you do to your truck today.The 3rd chapter

Made a Custom Cab cover for a neighbor.
https://scontent-sjc3-1.xx.fbcdn.net...8c&oe=5FA0CF1A

72c20customcamper

10-04-2020 07:51 PM

Re: What did you do to your truck today.The 3rd chapter

Quote:

Originally Posted by Astro-Balls (Post 8817857)

Made a Custom Cab cover for a neighbor.
https://scontent-sjc3-1.xx.fbcdn.net...8c&oe=5FA0CF1A

Would like to have a couple of those you should sell them .

pjmoreland

10-04-2020 09:42 PM

Re: What did you do to your truck today.The 3rd chapter

2 Attachment(s)

Installed a steel lever kit in my heater controls and replaced the defroster ducts. Got the parts from GMCPauls, and the quality is top notch on both.

Also installed some stock valve covers that I bought from Ironhorse. Still need to find a grommet for the breather.

Andy4639

10-05-2020 09:38 PM

Re: What did you do to your truck today.The 3rd chapter

I cut down the stacks to be able to pull into my garage if I need to.:chevy:

You Tube

67C10Step

10-05-2020 10:51 PM

Re: What did you do to your truck today.The 3rd chapter

Started putting the Inline Tube brake lines on my truck. Got the two rears along the rear end to the tee and flex line installed. Moving to the long line under the cab next.

OregonNed

10-06-2020 10:40 AM

Re: What did you do to your truck today.The 3rd chapter

1 Attachment(s)

New carb in - drove it to a cruise in last weekend and took this pic. This week I am checking timing and finishing up the set up. Went with a 500CFM on the engine. It's running great - very happy with the upgrade.

pjmoreland

10-07-2020 02:15 PM

Re: What did you do to your truck today.The 3rd chapter

4 Attachment(s)

Found what I consider to be a super nice door to replace my damaged door. I've been looking all over and everything has been excessively rusty so far. Found this one 15 minutes from my house at a private wrecking yard that's not open to the public. The guy there was super nice and helpful. I have been stressing out about being able to find a nice door, so this is a big relief.

1971Stepside

10-07-2020 03:12 PM

Re: What did you do to your truck today.The 3rd chapter

1 Attachment(s)

I just sat back and looked at it.

72c20customcamper

10-07-2020 03:38 PM

Re: What did you do to your truck today.The 3rd chapter

Quote:

Originally Posted by pjmoreland (Post 8819365)

Nice . I’ve been looking for a set for the 68 stepper. I bought a decent passenger door but would like rust free ones. May have to take a road trip to Phoenix to visit the cousin. And do some scrounging

Andy4639

10-07-2020 04:20 PM

Re: What did you do to your truck today.The 3rd chapter

2 Attachment(s)

Been wanting to get the letters shadowed now for awhile. Well today it got done and I also did the wheels on the 64 SS Impala while he was here at the house.
Those pictures will be in the general area.:chevy:

pjmoreland

10-07-2020 05:03 PM

Re: What did you do to your truck today.The 3rd chapter

Quote:

Originally Posted by 72c20customcamper (Post 8819399)

I can only imagine how hard it must be to find clean doors in NY

72c20customcamper

10-07-2020 07:41 PM

Re: What did you do to your truck today.The 3rd chapter

Quote:

Originally Posted by pjmoreland (Post 8819421)

I can only imagine how hard it must be to find clean doors in NY

Hard to find a 8 year old truck with no rust.

Happy_dan

10-11-2020 12:40 PM

Re: What did you do to your truck today.The 3rd chapter

Found a place top mount tires on original friction ring wheels. Sanded and painted wheels and cleaned up hub caps as best I could. I will only use these for pictures and shows but I like the original look.

https://photos.imageevent.com/happy_...e/IMG_7706.jpg

https://photos.imageevent.com/happy_...e/IMG_7707.jpg

Andy4639

10-11-2020 01:16 PM

Re: What did you do to your truck today.The 3rd chapter

4 Attachment(s)

Pulled the cluster out to see what happened to the tach.

Stud is broke off inside of it. I will have to call Manes in the morning to see if they will warranty it. It's less than a year old.
It just spins around it's not attached to anything. I can pull it up but not out.:chevy:

68bowtie

10-11-2020 01:33 PM

Re: What did you do to your truck today.The 3rd chapter

Quote:

Originally Posted by Happy_dan (Post 8820972)

Perfect!

Stover93

10-11-2020 04:00 PM

Re: What did you do to your truck today.The 3rd chapter

3 Attachment(s)

Painting is now complete! I see now why folks hire this done. It’s a ton of work!

jimijam00

10-11-2020 07:00 PM

Re: What did you do to your truck today.The 3rd chapter

Lowered the bench seat 2 inches with Full Custom Fab brackets, and wired up my audio system (Kenwood h/u and Infinity 4" and 6.5" speakers) from scratch.

All times are GMT -4. The time now is 01:36 AM.

Page 62 of 197

Show 40 post(s) from this thread on one page