Re: My winter project
3 Attachment(s)
I needed to free up some space before I start working on the doors. The motor is in and FYI install power steering bracket and trans line clip before you find out as I did and pull motor again.
|
Re: My winter project
5 Attachment(s)
Things are going back together. AC box cleaned and the case sealed.
|
Re: My winter project
3 Attachment(s)
Working on AC and heating ducting under the dash, there is a lot going on under there.
|
Re: My winter project
We need an update man!
|
Re: My winter project
4 Attachment(s)
Casey, your right needed to download phone pictures hope they work. Here is a small update. I completed the engine bay AC stuff and still working on under dash things. I repaired the cut radio hole, I got an aftermarket speaker because that will need to go in first or never get it in, dash pad, middle AC vent and ducting work my way down and out. I had a paint shop mix GM 521 to factory spec. and put in spray can application I'll post when I get the dash painted.
7D2N sorry for sideways pics can some one helpme turn them. |
Re: My winter project
4 Attachment(s)
Here you go
|
Re: My winter project
Thank You
|
Re: My winter project
5 Attachment(s)
Small update: I rattle can sprayed my dash with the 521 GM paint I had the shop mix and I think it worked out fine.
7D2N |
Re: My winter project
3 Attachment(s)
Dash cluster work.
|
Re: My winter project
I just read this whole thing and couldn’t stop until I read it all. Nice work.
|
Re: My winter project
Nice work....how hard is it too pull off the needles for the gauges
|
Re: My winter project
Quote:
Quote:
I didnt remove the needles, if you noticed the aluminum foil in the photo I cut small slots and slid it under the needles and pressed in place and used a brush on reflective needle paint. |
Re: My winter project
Quote:
Is the paint available online, looks like a good match |
Re: My winter project
Quote:
7D2N |
Re: My winter project
4 Attachment(s)
I completed a few things on and under the dash, kick panels vents rebuilt, all ductwork replaced and GM radio installed.
|
Re: My winter project
3 Attachment(s)
I'm really close for the gauge cluster going in.
|
Re: My winter project
Craig,
Good to see that you are making great progress. Looks great! Jothan |
Re: My winter project
3 Attachment(s)
Quote:
|
Re: My winter project
That looks so nice. I want a blazer now.
|
Re: My winter project
Quote:
|
Re: My winter project
2 Attachment(s)
Moving to the doors and I have some things to fix.
|
Re: My winter project
4 Attachment(s)
I had some sandblasting done on my doors and fenders, does anyone know how should I prep the surfaces until I can repair?
Thanks. 7D2N |
Re: My winter project
5 Attachment(s)
Started working on the doors and they need some patches. Any tips or advice on welding this together, butt weld, lap weld?
Thanks 7D2N |
Re: My winter project
I'd butt weld it. Nice work so far.
Good luck, Rg |
Re: My winter project
5 Attachment(s)
I'm fitting the patch panels on the doors, checking the fit and alinement before I cut for welding.
|
All times are GMT -4. The time now is 03:50 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com