Re: My 63 Project
 

Progress=:metal:
Nice goin! :chevy:

Re: My 63 Project
 

Little bit of paint on the trailing arms.

Re: My 63 Project
 

And of course new bushings.

Re: My 63 Project
 

And boy howdy getting this cross member out is a *****!!

Re: My 63 Project
 

Hmmm....That means I ain't gonna even attempt to pull mine! LOL! :chevy:

Re: My 63 Project
 

I won't lie, it sucked, but mostly because I was by myself, trying to get the rivets out laying on my back. If you have a really good air chisel, it shouldn't be as bad. And I had to pull mine as the PO had welded that angle iron piece in for the carrier bearing. And by pulling it, I was able to get it all cleaned up and now I can flip it which will help with the pinion angle and also to give me more play for the driveline.

Re: My 63 Project
 

Ok, so some grinding, clean up and a coat of paint. Trailing arm cross member ready to go back in.

Re: My 63 Project
 

Finished up the back of the cab, for the most part. I have a couple of small spots to address.

Re: My 63 Project
 

"flip it" do tell...I thought moving the trailing arm mounts was the hidden secret. Did you pull the whole enchilada to clean it up and paint it vs. flipping the brackets?

Re: My 63 Project
 

This picture is about the best way to really show. The clearance from the frame to the top of the driveline opening is about .5 inches stock. As seen in in this picture.

Re: My 63 Project
 

Close up.

Re: My 63 Project
 

Now the bottom side, stock has more clearance for the driveline. About 2 inches.

So, I pulled the entire crossmember, first to pull out that angle iron that the PO welded in. And since I now have it out, I can bolt it back in, upside down if you will. This will give me more driveline clearance on the top side of the crossmember. And since I have dropped the rear end four inches, it should be better for driveline clearance. Make sense?? If it doesn't work out, I can flip it back over without much work.

Re: My 63 Project
 

Trailing arms look good! Nice work! :chevy:

Re: My 63 Project
 

So I have been working a ton, and saving some money so I could get a new rear end as mine will not work. So I called Moser today, and they told me that they couldn't make a rear end that would work with my disc brakes. I called a local company, pretty much the same thing. So I was pretty bummed out.

I happened to check out craigslist today..... JACKPOT!!!!

12 Bolt, trailing arm suspension and 30 Spline!!!

Re: My 63 Project
 

After a little cleaning, it's ready to go to the machine shop to get checked out, new bearings and posi unit!

And it has 3.73 gears already.

Re: My 63 Project
 

Rear frame before.

Re: My 63 Project
 

And after!!!

Re: My 63 Project
 

And now the cross member flipped over and back in.

Re: My 63 Project
 

Coming along nicely!!

Re: My 63 Project
 

Look what I picked up today.

Re: My 63 Project
 

So we had a very productive day... Started off with the brake booster and master cylinder. That's my son helping out.

Re: My 63 Project
 

And here is an after picture.

Re: My 63 Project
 

Then we moved on to the power steering gear box. And the steering linkage.

Re: My 63 Project
 

And the steering column.

Re: My 63 Project
 

Then I went to the shop and picked up the rearend.