Originally Posted by LSUMurse (Post 6696764)

I have a '68 with a hole for the choke cable that I am no longer using. Do you think the remote switch has enough threads to be able to, reach through the thickness of the bezel there? Also, will it accept a knob like the one on the windshield wiper switch?

If so, this could be made to look almost stock in a '67 - '68 cluster.

I apologize if this has already been gone over, you've gotten too much attention for me to read through.

Originally Posted by TobyArnot (Post 6697265)

The threads on Tom's switch are very short. Suggest you go back in this post to #88 & #90. I had to open up the steel dash where the choke hole was in order to allow the switch to mount directly to the front panel. Also, you can see the Radio Shack knob i used. The switch shaft is fairly small and the W/W knob would likely not fit very well. JMO.

Originally Posted by LSUMurse (Post 6700584)

I'll take one. PM me.

Originally Posted by 69-72 (Post 6702253)

Ill take one shipped to 58271.

Originally Posted by esoxman308 (Post 6709052)

I'll take one shipped to 58740 (ND)...Thank You....Lee

Originally Posted by LSUMurse (Post 6709805)

Installed mine today. It works perfectly and I'm sorry to hear that you're no longer going to make them.

http://i.imgur.com/IkWKq9j.jpg

http://i.imgur.com/Y4bC9K2.jpg

Not too bad on a '68 through the choke hole that I no longer need. If I had a drill press, I could make a bushing to be able to put a bezel on it and make it look even more stock.