7/8 hex lug nuts
Anyone know where to get 1/2 lug nuts with a 7/8 hex like original?
|
Re: 7/8 hex lug nuts
Never seen that, 1/2'' with 13/16'' was common
|
Re: 7/8 hex lug nuts
Quote:
|
Re: 7/8 hex lug nuts
I assume by the OPs signature this is for the K20:
3/4 ton trucks of that era run a 9/16" - 18 lug nut. Thus the 7/8 inch lug wrench. 1/2 ton trucks used 1/2" - 20 lug nut with the 13/16 wrench. Dorman - Autograde - Wheel Nut 9/16-18 Standard - 7/8 In. Hex, 3/4 In. Length (sold by each) (Part No. 611-052) I went to Napa to buy some when I built my spare tire carrier. I wanted the nuts to hold the spare to be the same as the lugnut so I could remove the spare using the lugwrench |
All times are GMT -4. The time now is 05:48 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com