Re: Ford Windstar E-Fan Wiring Question
 

hopefully you guys can help me little more. i got the jegs dual fan relay with threaded in temp sensor. do i just wire up on fan off both relays or to both fans. then when it hits the temp both fans come on?

Re: Ford Windstar E-Fan Wiring Question
 

The Windstar fans are each dual speed- you'll need to power both fans on low from one relay, then both on high off the second relay-however, keep in mind you can't power low speed while high speed is activated-it'll burn out the fan windings. Most "generic" aftermarket fan relay kits are not intended to be ran on anything other than a simple single speed fan. And those Jegs relays better be STOUT if you plan to use anything OEM for an electric fan.

Re: Ford Windstar E-Fan Wiring Question
 

the relay kit i got is Part Number: 555-10570 from jegs. would i be better off going with the cheeroke fan?

Re: Ford Windstar E-Fan Wiring Question
 

That relay kit isn't designed for a dual speed/dual fan setup. As for the Cherokee fan I have no comment because I don't use those fans-however being a chrysler OEM fan those too would be a dual speed fan.

Re: Ford Windstar E-Fan Wiring Question
 

any suggestions of fan to use with that relay kit?

Re: Ford Windstar E-Fan Wiring Question
 

I have used the jeep 2001 ish grand Cherokee fan in factory shroud. Its a 2 wire hook up so I doubt its a 2 speed fan. 1 ground 1 power wire

Re: Ford Windstar E-Fan Wiring Question
 

Reviving this thread as a couple of us are in the midst of this wiring.

dayj1-your pictures from post #49 seem to be broken, can you repost the bottom two?