High Hump Cutout
Hey guys, I have a curiosity... I have ordered a high hump trans tunnel for my DM/LS swap C10, but the hump wont be in until next week. Im looking to get my engine installed this week and I want to cut out the section where it will sit. Is there a template or a stamp mark in the floorboard that might be a good reference?
I appreciate the help!:metal: |
Re: High Hump Cutout
3 Attachment(s)
I did this last weekend. do not have any good pics but these. hope it helps
|
Re: High Hump Cutout
|
Re: High Hump Cutout
DON'T DO IT.
Wait until you have the replacement piece. Cutting before then might result in a big headache if your calculations are off. I've learned the hard way to wait until I have all the pieces on hand before moving forward. You can wait a few more days...find something else to do. |
All times are GMT -4. The time now is 06:38 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com