Re: thinking about getting this in the morning
Lookin good man!!
|
Re: thinking about getting this in the morning
Quote:
|
Re: thinking about getting this in the morning
Looking good!
|
1 Attachment(s)
New windshield going in
Posted via Mobile Device |
Re: thinking about getting this in the morning
Quote:
Truck looks great! Thanks, Mick |
Re: thinking about getting this in the morning
2 Attachment(s)
po put some kind of foam in the roof unless they all come like that? i couldn't tell you
|
Re: thinking about getting this in the morning
4 Attachment(s)
i didn't take any pics of the cleaning all the crap out of there it was a mess we blew it out for hours then soaked it down with rust inhibitor till it ran out the bottom there is a little drain that runs out the sides to the rear of the B pillar we were careful not to clog them up when repairing everything else. once it was all cleaned out and new metal welded in we used duraglass with the fibers in it that stuff hardens like a rock man!
|
Re: thinking about getting this in the morning
OK, thanks for the extra pics. Guess I'll just break into it and hope for the best. Projects like this are good inspiration. Thanks again man. Good luck.
|
Re: thinking about getting this in the morning
here are a couple of the duraglass before sanding
|
Re: thinking about getting this in the morning
2 Attachment(s)
Quote:
|
Re: thinking about getting this in the morning
2 Attachment(s)
like new!
|
Re: thinking about getting this in the morning
2 Attachment(s)
|
Re: thinking about getting this in the morning
4 Attachment(s)
a few more pics
|
Re: thinking about getting this in the morning
4 Attachment(s)
few more just can't stop staring at her pictures aren't doing it any justice! we are amazed how nice it is coming out going to wetsand and buff before we start installing all the new goodies but couldn't resist putting on one lens!
|
Re: thinking about getting this in the morning
4 Attachment(s)
decided to spray the undercoating on the bottom side of the truck while we have the wheels and tires off getting sprayed and before we wet sand buff
|
Re: thinking about getting this in the morning
That B-pillar drain, I never knew it was there. Where does it drain from? The top seal? I think your PO added the spray foam. I had to dig in the inner cab a little recently on my 85 and it had a sticky tar-like something or other on the backsides of the metal in there.
|
Re: thinking about getting this in the morning
1 Attachment(s)
Quote:
|
Re: thinking about getting this in the morning
2 Attachment(s)
funny i went to install the side steps i picked up and found all the holes predrilled in all the exact locations seems the PO must have had the same steps installed at one point we sprayed bedliner to the underside of the body and up in the fender wells before we wet sand today so any overspray will get taken care of at the same time starting to look good I'm digging it!:smoke: not sure why some pics get turned sideways they were straight when i attached them?
|
Re: thinking about getting this in the morning
I have the same ones....very handy!
|
Re: thinking about getting this in the morning
5 Attachment(s)
finally getting to install some parts
|
Re: thinking about getting this in the morning
:metal::metal:
|
Re: thinking about getting this in the morning
Looks fabulous!
|
Re: thinking about getting this in the morning
thanks you're feeling it too right? i swear i can't stop staring at her. :smoke:
|
Re: thinking about getting this in the morning
hopefully we will get the door handles hooked back up and then all the moldings, side steps and the new bumpers.
|
Re: thinking about getting this in the morning
I'm ready to see how the lower molding looks on it.
|
All times are GMT -4. The time now is 10:06 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com