What did you get done this week ( end) 12'1/2019 edition
 

spent a few hours doing some more work to the 76K20 wheel arch moldings installed installed new front bumper.Started installing the rollbar and tried to install back bumper. The back bumper they sent me is the wrong one so a new one is on order but not going to ship until mid month and the old one is off so more hurry up and wait. Hopefully I can begin on the interior this week
Threw the plow on the 98 totally so we are ready for winter and then my son came over and we installed the trans in the 05 Dodge but there's more problems so either the harness or the TCU is bad... never ends
How about you all?

Re: What did you get done this week ( end) 12'1/2019 edition
 

I got ambitious and installed my shelf thing-a-ma-bob.

Re: What did you get done this week ( end) 12'1/2019 edition
 

Where did you get it from?

Re: What did you get done this week ( end) 12'1/2019 edition
 

More progress on my 81 C20 to K20 conversion. Removed the cab, 2wd turbo 400 transmission and drive shaft to install the front Dana 44 axle that is out of the same truck the Corporate 14 bolt full floater was in, turbo 400 trans, 203 transfer case, rear and front drive shafts.

Re: What did you get done this week ( end) 12'1/2019 edition
 

Busted out 10 rivets in the continued process of doing the blazer tank swap. I wanted to have it all done this weekend. But those rivets had other ideas. 1 busted air hammer, 3 or 4 broken drill bits, profanity, sledgehammer action, and more raised blood pressure than is ever healthy...ill settle for clear frame rails and work on the braces next weekend.

Re: What did you get done this week ( end) 12'1/2019 edition
 

This Black Friday/Cyber Monday madness needs to stop, my PayPal account is hurting!

Still out of town for work but the packages keep coming and work list at home keeps increasing.

Re: What did you get done this week ( end) 12'1/2019 edition
 

Re: What did you get done this week ( end) 12'1/2019 edition
 

Shelf thing-a-ma-Bob, that’s funny. The Cardboard Tool Tray, was something that a lot of our trucks had, when they were new. Part of an option. They tend to waste away to shreds over time. When I installed mine, I wrapped it in amp/speaker carpet, to help it last for years.
Now, for what I got done this weekend. Got some sandblasting done, on a lot of my seat hardware. Still have a lot to do yet.
Also got a set of Burgundy seatbelts, that I got all cleaned up. Now I’m going to get all the plastic prepped and dyed.