Need to install AC vent "balls"
I've seen different posts with members using various methods to layout holes to cut in dash for AC vent balls and was wondering what works best. I'm leaning towards using the actual factory vents that have been trimmed in back to lay flat on dash to draw an outline. The center vent has already been installed correctly, but square holes were cut in each side of my dash where someone put in vents from an 86 Buick or something. Any thoughts? Mike
|
Re: Need to install AC vent "balls"
I have a set of patterns I cut from an old dash, you can borrow them for $35 which includes shipping both ways. I will include a return usps label.
|
Re: Need to install AC vent "balls"
Any other input, or is this the best method?
|
Re: Need to install AC vent "balls"
|
Re: Need to install AC vent "balls"
3 Attachment(s)
I did the dame thing Randy did, used old dash cut outs as a template.
|
All times are GMT -4. The time now is 12:30 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com