Plug Wires
im going to relocate my coils to the back of the engine...for those that have done this what are the better ones to use..im guessing there are some kits for this...id like to use 10mm wires if possible
|
Re: Plug Wires
1 Attachment(s)
D7I used an 8mm Taylor cut to fit set made for an LT1. The LT1 has the same ends on the Optispark as an LS coil, unlike the older HEI wires. Depending on how you mount your coils you may need either straight or 45* ends. The Taylor numbers are 46052 for the straight and the 45 deg version is 46069.
|
Re: Plug Wires
Thanks Eric !!....I'll check them out....I had forgotten about taylor...
|
Re: Plug Wires
I used MSD 8.5's. The kit I got was LS specific and came with either 90's or a straight/multi angle up to roughly a 45 degree for the plug side. I believe only 45's for the coils, but cant remember for sure now. Havent ran it yet, but i like them based on looks.
|
Re: Plug Wires
Thanks sprint..those look good..
|
Re: Plug Wires
Quote:
|
Re: Plug Wires
Zep..that intake looks just like the one I have..If so its a holley 300-137....you would also need the Holley fuel rails....dayj1 did a great job on his and I'm kinda following what he did..http://67-72chevytrucks.com/vboard/s...ght=Skin+a+cat
|
All times are GMT -4. The time now is 03:12 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com