Quick Tune-up Question
I'm doing a tune-up on my '72 350 and was wondering how do I set the gap on the points?
Do I bring the #1 cyl. to TDC and then set them? What are the supposed to be set at? The last time I did this was about 15 years ago......now I can't remember. Thanks ------------------
eagle571@hotmail.com http://communities.msn.com/196772ChevyTrucks Vermilion, Ohio |
ttt
|
just tap your starter iwht the distributer cap off untill the points are separated as far as they go. adjust with an allen wrench untill a matchbox lid will hardly fit between them. use a dwell meter if you have one. the meter should read about 28. good lcuk, Ben
|
Just roll the eng so that a dist lobe is at the high point on the points(any lobe),& set the gap @ .019. then roll it to close the points,& slide a business card through to clean the contacts.....69 longhorn.
|
thanks y'all.......'preciate it.
|
All times are GMT -4. The time now is 11:11 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com