4l80e wiring connector leak
 

Have a non-op project with a 4L80E rebuild transmission, installed. Went to fill it with ATF and after filling to a certain level, started pouring out of the case connector for my control electronics. I've seen these out of the trans and looks like they are a single o-ring seal with lock tabs. I pulled on it, pushed on it, twisted it and can't seem to get a lock seal. The slightest push inward and the seal breaks. Anyone else run into this problem? Any ideas? Trans was rebuilt by a reputable local company that's been around awhile. I'll call them also, but thought I'd try the forum as well.