flowmaster 817654 stainless kit
 

anybody use this Stainless Kit and can give some advice or recommend I want to run shorty headers( maybe ) may go with long tubes.... not sure yet, on a 350 and want to put it thru the ECE dropmember run the mufflers top of trail arms and most likely out the back if someone has used this kit be interested and any pictures would be great
Here is the info right off their site

817654
Exhaust Systems / Kits - American Thunder®
Crossmember back 409S - Dual Rear or Side Exit - Moderate/Aggressive Sound
Fits 1967 to 1972 Shortbed/Longbed GMC and Chevrolet C10 and C15 1/2 Ton 2 wheel drive pickups with a V8 engine using the coil spring suspension only

Re: flowmaster 817654 stainless kit
 

Old post but I’m also considering the flowmaster kit for my 68 C10 SWB with static 6-8” drop. I’d like to see side view pictures of the setup installed, looks like pipes run below part of the frame. If anyone with that Flowmaster kit can post some pictures of the exhaust I would be great full. I want to see if it hangs down noticeably low where it may be a clearance issue

Re: flowmaster 817654 stainless kit
 

I never used the entire kit I didn't like how low it hung with a 4-6 static drop I fabed up some of the kit to go though the ECE trailing arm crossmember haven't finished that part of my build ..if I had it to do it over I would have bought certain parts from flow master not the kit ill try to post some pics or you might want to see it my unfinished stalled :( Doc and Kim build... post 258 or 275 hope this helps