What wheel studs
 

I'm assuming I have a later truck rear as it's a 5x5 patern. Anyone know what rear wheels studs are needed? Snap one and want to replace with like ARP or something else legal.

Re: What wheel studs
 

I would go to a 1/2 inch long stud and open ended lug nut. Some of them screw in from the rear of the axle. Just check Jeg's or Summit.

Re: What wheel studs
 

I was going to go with press in's. Any idea regards to the knurl size? I have 1/2-20's right now, but like you mentioned I want to go open shank style.

Re: What wheel studs
 

Super I am currently shopping for the same thing and here is what I have found so far. I am also 5x5 1/2x20 thread.

I knocked one of my wheel studs out just over the weekend and it measures .524 on the knurl. The smallest stud I can find has a .530 knurl and the length is the same as this one. I too am going to a longer stud. So, I'm gunna buy some studs that have a .560-.565 knurl and just trim the axle a bit if that knurl is too large to pop the cherry :)

Re: What wheel studs
 

go here and scope out the 8138's

http://www.moserengineering.com/Page...heelstuds.html

Re: What wheel studs
 

Those may work for Super.

Me.....I'm looking for something that's 2" in length minimum.

Re: What wheel studs
 

If you guys are going to run Weld draglites your going to need 3" studs and the really long shank nuts.

Re: What wheel studs
 

Here's what I'm going to run in my new 9".

Re: What wheel studs
 

Might be able to get these in..

http://store.summitracing.com/partde...5&autoview=sku

Re: What wheel studs
 

That's what I got in my junk!

Re: What wheel studs
 

I think those are the ones I am going to buy also...

Re: What wheel studs
 

Those will need massaging. I actually ground a little off of the start of the knurl and forced them in. You will surprised hom much needs to be removed.