dana 60 help
i have a 1971 c20 with the eaton ho52 and 5.13ish gears and it tachs bad on the freeway, i picked up a dana 60 from a 1970 c20 big block truck for under $150 and was told its 3.54 and possible power loc i have a sm465 right now and was wondering if anyone ever swapped just the rear section of the driveshaft with the rearend so i wouldnt have to shorten it just swap rear of the carrier bearing? and also anyone have info on a saginaw 3 speed with an eletric overdrive got one for 25 bucks from a 1967 c10 and might want to use it
|
Re: dana 60 help
Shortening is easy and cheap. Is the 70 driveshaft available? Pop the cover on the 60 and get the ring and pinion tooth count. Powr-Loc looks like this http://www2.dana.com/pdf/5315-3.pdf
|
Re: dana 60 help
The 70 driveshaft is avavble wondering if I can just swap the part that's goes from the axle to the u joint by the carrier bearing and I piped the cover it's a open diff and is there anyway to get a replacement of the stud that bolts into the diff to mount the trackbar mine is rusted really bad can post pics if it helps
|
Re: dana 60 help
You can do it as long as both drivelines have the same carrier bearing, but you will have to have the driveline balanced. However just a direct swap with nothing else, that would be a no. As far as finding a stud, you may want to post a WTB thread in the parts board. WES
|
Re: dana 60 help
thanks anyone know if that stud is remanufactured by anyone
|
All times are GMT -4. The time now is 11:48 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com