![]() |
Loose Column shift lever.
After rooting around for a while, and probably not looking at the right spot, I
would like to ask if there is a way to tighten up my shifting lever on my burb. It goes into gear just fine, but there is a lot of play in it. It is loose and flabby........ I want to replace it (in the future, but would like to find a temporary solution now) Thanks for the help... jeff |
Re: Loose Column shift lever.
anyone..........anyone...............Bueller..............
By the way... It is an automatic. I migiht have mis-named the part... thanks jeff |
Re: Loose Column shift lever.
OK, let's start with the obvious. Is the pin that holds the actual lever in right? Is it worn? You probably have a little play in several places. Beyond that, check the linkage from the column to the tranny. There are several places in there that can get loose.
|
Re: Loose Column shift lever.
Thanks Mr. Fry.
|
All times are GMT -4. The time now is 12:30 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com