Rebuild 350, 383, big block swap?
I have 71' C20 with a 350 sb and unknown automatic trans. At its current condition it runs and drives fine but feels weak.
I wanna know what would be the best route. Ive heard that I can make my 350 more powerful as a 383 stroker but I have no idea how to go about this. I plan on taking it to a rebuilder but I want to know as much as possible before I take it in. Or should I drop in a 454 bbc? If I do that what do I need to change? Trans, engine mounts, ??? I plan on towing and pulling a camper trailer.. |
Re: Rebuild 350, 383, big block swap?
Since you plan on towing I'd say either the 383 or 454.
The 383 is basically the same as a 350 with the exception of a longer stroke crank and pistons with a shorter pin height. The rods can be reused or can be longer (6.0" vs stock 5.7") but that just adds more cost as the longer rods are more expensive as is the shorter pistons. The 383 may get better fuel mileage when not towing but that's hard to say. Depends on how much weight you will be towing and the number of miles you drive while towing. Is it basically flat land or lots of hills? Also, are you going to be mainly towing or just ocassionaly towing? Lots of variables here ... |
Re: Rebuild 350, 383, big block swap?
Big Block and Th400 or 4l80E. Once you go Big Block you never go back!
|
Re: Rebuild 350, 383, big block swap?
If your 350 runs fine, why not just upgrade your cam? Quick and easy power increase.
|
Re: Rebuild 350, 383, big block swap?
Wow a lot to think about.. I appreciate the insight from everybody.
Also.. How do I figure out what transmission I have? (know stupid question) It is an automatic three speed. If I go big block will my trans bolt up? If not what would be a good automatic trans to run with a bbc such as 454. |
Re: Rebuild 350, 383, big block swap?
Crawl under and look at the pan.
http://www.probuildamerican.com/wp-c...-pans-id-1.jpg Your choices will be limited if you intend to use a 383 or a BB for towing. TH400 or 4L80E if you want success. As for whether to go 383 or BB, either one will work pretty well. You will have some chance at economy if you go with a 383 and the proper cam. Plus all of your accessories, mounts and brackets will still work. |
Re: Rebuild 350, 383, big block swap?
It should be a 350 turbo trans.
|
Re: Rebuild 350, 383, big block swap?
3/4 ton could be either a 350 or a 400. Look at the chart above, unless you have a pic of the spid sheet in the glove box
|
Re: Rebuild 350, 383, big block swap?
Quote:
|
All times are GMT -4. The time now is 04:59 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com