66 chevy 3/4 ton project need help
 

I have a 66 chevy project have to replace cab do to a lot of rust.. but i have been looking for anything to help I need to know if a 64 chevy cab will work on a 66 chevy frame some stuff doesn't line up but other stuff does.. any ideas?

Re: 66 chevy 3/4 ton project need help
 

Should fit right on there. What doesn't line up?

I just found out it's. C60 model which those are wider
Posted via Mobile Device

Re: 66 chevy 3/4 ton project need help
 

Cab or frame is C60? Any pics?

My frame is a c25 model 3/4 ton the cab I just bought ended up being from a c60 model 1964 2 ton truck (my truck is the green cab and the 2 ton is orange)
Posted via Mobile Device

Re: 66 chevy 3/4 ton project need help
 

Not an expert by any means, but I do know the C60 inner fenders mount somewhat differently and are about an inch shorter than the C10/20 ones. Attached is a pic of a '61 C60 cab that shows the same inner fender mount. I was under the impression that the actual cabs were pretty much the same. Which cab do you want to use?

That's what I was under the impression. The c60 apparently are wider. The front cab mounts on the c60 mesasure from center whole to center whole about 50 inches. The wholes on my cab are about 40 some inches... looks like I'm going to need to cut he c60 up and use its floor and modify to fix my cabs floor I haven't quite set it on the frame yet tho
Posted via Mobile Device

The 64 through 66 cabs are matches but apparently only between c10-c20 models they bolt with no issues
Posted via Mobile Device

Re: 66 chevy 3/4 ton project need help
 

Hello! I'm not an expert in all this yet, but I'm interested in such questions. I esteem your opinions, I think it will come in handy.