WTB: one exhaust manifold bolt for SBC w AC
 

Chasing the exhaust manifold bolt for 350 SBC w AC - the most forward RH bolt as shown below. I believe it's double threaded and doubles to attach one of the AC compressor brackets. Mine was tossed by a PO when the headers went on. Thanks. Pete

Re: WTB: one exhaust manifold bolt for SBC w AC
 

PM Sent...

Re: WTB: one exhaust manifold bolt for SBC w AC
 

Reply sent. Yep, it would resemble one of the bolts used for the water pump but the portion of bolt that runs through the AC bracket is longer at ~ 2 in total length.

Re: WTB: one exhaust manifold bolt for SBC w AC
 

Measures 1 5/8 one side, exactly 2 inch other side total. Measured from bolt face opposing.

Not perfect but chased it with 3/8-16 die then ran a nut down both sides. Whatcha got for a trade.

I could really use a cast iron thermostat housing with little or (no rust) hopefully.

Re: WTB: one exhaust manifold bolt for SBC w AC
 

Or a Power Steering Pump V-Belt pulley with no wobble. Let me know what ye have!

Re: WTB: one exhaust manifold bolt for SBC w AC
 

Thanks! I'll take it. Happy to trade - I know I have a good spare OEM t-stat housing from a SBC without that threaded insert but for some reason am thinking it's aluminum rather than iron. Does that sound right? I'll have to double check on the pulley - not sure if there's one attached to a spare pump I have boxed up.

Re: WTB: one exhaust manifold bolt for SBC w AC
 

Deal.