need help w/points to HEI conversion
 

i have a 1965 chevy suburban w/points for ignition. i have a hei distributor to replace the old one. what i don't know is where to hook the wires from the coil and starter to!!!i realize i have a 65 but i visit this message board all the time. you have more people on this board than mine!!any help would be greatly appreciated...... ps...all chevy trucks rule(gmc too!!)

snip them, or tape them off! dont hook them up they are unneccasry now
just run a 10 or 12 gauge wire from the fuse panel "ign unfused" port to the batt terminal on the HEI

------------------
My Truck pictures

www.xframeimpala.com

68 4x4 short fleetside 327 CH465 edelbrock intake and carb MSD distributor its the "SHAGROLET"
56 big window short stepside 235 dual 1 brls
64ImpalaSS 327
70 C10 LWB fleetside custom/10 350/TH350
IM me on aol SN= SHAGROLET

12 gauge is way palenty, even 14 is plenty, no need to go overboard on wire size....
ywllow and white wires that ran to coil are now useless, lose thewm, thwe yellow onl;y runs from + on coil down to R on solenoid

happy HEI swapping

I ran 10 guage on mine.....better safe than sorry........69 longhorn.

thanks a bunch guys........hope to have it done tomorrow.....may even post some pics of the burb even though it's a 65....thanks again HEMMIT