Gas tank and guage S-10 swap
ok, not posting this in my thread because I would like to have more eyes on this one. So I am doing and s-10 frame with gas tank in it's stock location.
The gas gauge is original and I have it set up for 12v. Now to my knowledge the sending unit in an s-10 tank is 90ohms where as the original guage/sending unit is 30 ohms. So how can you use the stock tank and sending unit and have the gas guage read properly? I was contplating fabbing up the original tank and buying an aftermarket 12v sending unit for it. It is too bad those wouln't fit in the s-10 tank. I don't want to run the tank like the blazers, and or past the axle where the spare would theoretically go. Any ideas? any pics of an original tank mounted to the s-10. P.S behind the seat is completely out of the question for me. Anyone have success running the OG gas guage with and s-10 tank and have it read properly?? thanks |
All times are GMT -4. The time now is 11:43 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com