TH350 Vacuum Hose Keeps Popping Out
The vacuum hose that goes from my Carb to my TH350 keeps popping out on the transmission module.
I did cut the tube about 1/2" hoping it'd get a little more snug, but every time I crank her over, it pops out. Just checking to see if there are any tricks to keep this line on before I get in the "Replace it" lane. Silicone? Bigger Hammer, haha? Thanks in advance for any replies. |
Re: TH350 Vacuum Hose Keeps Popping Out
Strange!
Maybe the modulator is kaput! |
Re: TH350 Vacuum Hose Keeps Popping Out
That is very strange. That's a vacuum line - the vacuum should be pulling on, not pushing it off.
Is it possible that it's so short that vibration is pulling it off? |
Re: TH350 Vacuum Hose Keeps Popping Out
Hose clamp?
|
Re: TH350 Vacuum Hose Keeps Popping Out
Hose clamp or zip tie allso make sure the line is secure from manifold to modulator or try a smaller id hose
|
Thanks all. Will give ideas a shot.
Posted via Mobile Device |
Re: TH350 Vacuum Hose Keeps Popping Out
This is a job for a zip tie.
|
Re: TH350 Vacuum Hose Keeps Popping Out
Could you post a pic of the outside of the modulator where the hose keeps "popping out"....
Thanks :chevy::chevy::chevy: |
All times are GMT -4. The time now is 02:40 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com