Re: Blazer interior rear panels
 

Might be a dumb question, but would these patterns include one for the drivers side and one for the passenger side? I was not sure if they were exactly the same, only reversed or if there is any specific differences or cutouts between the two sides.

If you take Paypal, I would be interested in a set of patterns, just would need to know the shipping cost to zip code 93637.

Re: Blazer interior rear panels
 

I too am really interested in the paper patterns for the panels. How much to ship them to 92315?

Do you also have a drawing or anything for the standoff brackets?

Thanks in advance!

Chris

Re: Blazer interior rear panels
 

You still offering panel patterns?

Re: Blazer interior rear panels
 

This is what I did for my '70 CST
3/16" textured ABS plastic sheet....less than $100 for a 4' x 8' sheet
anodized aluminum "J" trim
vinyl push-on trim for the edges
I found a pattern with the dimensions on line
these fit so snugly...I only put in 4 trim screws to hold them
The only issue is black only....which was fine for me when I switched from blue to black interior

Attachment 1931817

stopped it at the B pillar and added the vinyl trim
Attachment 1931818

Attachment 1931819

you can see one small black screw here
Attachment 1931820

Re: Blazer interior rear panels
 

[QUOTE=A1971Blazer;8581705]This is what I did for my '70 CST
3/16" textured ABS plastic sheet....less than $100 for a 4' x 8' sheet
anodized aluminum "J" trim
vinyl push-on trim for the edges
I found a pattern with the dimensions on line
these fit so snugly...

Do you happen to remember where you found the pattern? Thanks

Re: Blazer interior rear panels
 

That looks better than the stock ones !

Re: Blazer interior rear panels
 

PM me and I'll send you a PDF file
I can also get you the info for the trim
Attachment 1931942

Re: Blazer interior rear panels
 

Also Azek PVC board comes in 4' x 8' sheets. Smooth finish, 3/8" is what I used,..About $80. scuffed and primed with epoxy paint, urethane base coat over. No top trim, pvc piece glued 90 degrees on top, cut to fit the profile. 4 screws hold it in place.

Re: Blazer interior rear panels
 

I see a guy on Ebay is selling what looks like a repro rear side panel; have you looked into that option?

Re: Blazer interior rear panels
 

A1971Blazer- Where did you source your plastic and j channel....... Looks good, might be a market for these

Re: Blazer interior rear panels
 

The plastic sheet came from Piedmont Plastics locally...most all plastic suppliers have it...ABS "hair cell" sheet 3/16" thick

The J channel and vinyl push-on trim came from McMaster-Carr supply Co

aluminum J channel https://www.mcmaster.com/8427a64
trim material https://www.mcmaster.com/8451a47

Re: Blazer interior rear panels
 

Following

Re: Blazer interior rear panels
 

They look awesome

Re: Blazer interior rear panels
 

Good stuff