Cummins Transmission crossmember
5 Attachment(s)
Anyone have pictures of their transmission crossmember?
I’ll soon be fitting mine and looking for ideas...I’ll be running a 47RH transmission Attached photos of my progress - 1972 suburban 4x4 frame, Cummins 12v with Rob Bonney box kit - I’m not the welder. |
Re: Cummins Transmission crossmember
On my 72 I used 2x4 1/4" wall and made a completely new cross member. Using a stock cross member will be tough because your boxing plates won't allow the stock one to set inside the frame. Unless you plan to bolt it under the frame?
|
Re: Cummins Transmission crossmember
this is what my 2002 ram 2500 cross member looks like
https://www.ebay.com/i/363081831901?...yABEgLKLfD_BwE much better options out there or fab one to match your rails |
Re: Cummins Transmission crossmember
Dieselwrencher -
What did you use then for transmission mount? I’m referring to the rubber mount that buffers vibrations etc |
Re: Cummins Transmission crossmember
3 Attachment(s)
I used square tubing and the stock mount just made a adapter.
|
Re: Cummins Transmission crossmember
I don't like being negative, but i have to ask if you have trial fit the motor in the mounts with the cab and core support in place. I also bought the rob bonney mounts and frame kit and just started assembling it all. If i remember correctly the instructions said to start mount placement 18" ahead of shackle mount. I found that to be about 5" too far forward. Using the 3 holes on top of the frame as reference, the front of the motor mount plates line up with the rear hole. Looking at your pictures, I'm afraid you may be 4-5" too far forward. I hope I'm wrong for your sake, but I had to ask because your pictures don't look like mine.
|
Re: Cummins Transmission crossmember
In the picture my engine crossmember isn’t welded in place - it’s to be determined where it will go based on test fitting the engine & transmission.
Engine & transmission should be back from the shop & will take it and frame with body bolted to the frame back to fab shop for final fitment. I’ll post results soon |
Re: Cummins Transmission crossmember
I used a stock 84 cucv cross member and dodge mount when I had a 47rh. then when I went to a nv4500 I used my stock 88 cross member and mount.
|
All times are GMT -4. The time now is 01:08 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com