1972 Big Block engine and parts
 

Back after a long break to sell remaining parts. Updated as of 5/9/2020 to reflect what I have for sale now.

1972 396/402 engine (longblock minus intake) with 41,000 miles. Had stuck lifter so assume you'll need to rebuild. 500 or 700 with intake and valve covers/wire loom pieces
1972 Th400 transmission with 41,000 miles. Unknown condition. Includes torque converter.
PS Pump with all brackets and bolts/washers/nuts 220
Alternator brackets with all bolts/washers/nuts 120
BB pulleys 150 (A/C and smog parts gone)
Air cleaner with spark arrestor and factory wingnut 120
Original radiator (LEAKING) $40
BB Flywheel 40
BB factory valve covers (have dents) with Wire loom pieces 50
BB Factory correct date intake with choke and water neck 100
BB wiring harness still flexible and complete 100
Everything for 1000
These parts are also for sale locally and local pickup preferred to shipping.

Shipping is extra and will be calculated by part or group of parts purchased.

I will take the tube and valve covers do you have pics
Posted via Mobile Device

Re: Big Block parts
 

Got it. I'll post pictures by tomorrow or Monday at latest.

Re: Big Block parts
 

Put me in line for the heat riser tube.

Thanks

Re: Big Block parts
 

Is the radiator a Harrison? Any pics?

Re: Big Block parts
 

Got it

Yes,

I will take the tube and shield any pics of valve covers and is the smog setup for sale?
Posted via Mobile Device

Re: Big Block parts
 

I will take the fan shroud pending pics.

Re: Big Block parts
 

Shield as in heat shield? Just confirming.

I'll get a picture of the valve covers off later.

Does the rusted shield go with tube? Is the smog setup for sale? and also interested in pulleys is the water pump 3 groove
Posted via Mobile Device

Re: Big Block parts
 

Have all clips and hardware. One blemish shown on closeup.

Re: Big Block parts
 

Yes, there's only a little over half left but yes, it's included. Was thinking you meant the exhaust heat shield.

Yes, pulleys are for AC and smog so three. Smog setup is sold.

Re: Big Block parts
 

I will take it, please PM payment info. Thanks

Okay, let me get a box for it and figure up a cost for shipping.
Posted via Mobile Device

Re: Big Block parts
 

Sounds good, zip code is 40353. Thanks

Re: Big Block parts
 

Pretty sure I have the other wire separator still attached to the plug wires.

Re: Big Block parts
 

Hard to tell from pics any dents?
Posted via Mobile Device

Re: Big Block parts
 

I don't think there are any dents. I'll check tomorrow.

Re: Big Block parts
 

will take the tube how do you take paypal?

Re: Big Block parts
 

do you still have the alternator bracket and is it for the drivers side?

Re: Big Block parts
 

Yes, I take PayPal. Will try to fit in a flat rate box to save on shipping. Can you give me your zip so I can confirm and get you a total? Thanks.

Re: Big Block parts
 

Yes, and yes. It's the correct factory side brackets. It has several brackets and all the hardware.

Re: Big Block parts
 

zip is 85203 still interested in valve covers if dent free shipping on those?

Re: Big Block parts
 

i do not know what the correct side is, only that my truck was a straight 6 with a fresh installed BBC and the alternator lead is only long enough to reach the drivers side. which hoes for mounting does this use? i am very interested
, just want to make sure it will work for the application I need it for. Thank you!

Still for sale?
Posted via Mobile Device