Parting 77 Scottsdale 1/2 ton 4x4
 

This was a good running truck EDIT THIS TRUCK IS LONG GONE. I will be using the engine for my 83, but everything else is for sale.
clutch/brake pedal assembly...$30 plus shipping
cargo light...$26 shipped SOLD
gas tank mounting brackets with straps...$10 each plus shipping
3.07 axles...$250 pair local
side mirrors, right side has chips...$20 pair plus shipping
woodgrain dash insert...$20 plus shipping if the studs don't break
truck carcass...about 9 cents per pound;)

Re: Parting 77 Scottsdale 1/2 ton 4x4
 

tough time uploading pics...wild blue internet service:waah:

Re: Parting 77 Scottsdale 1/2 ton 4x4
 

inter fender any good and fenders

Re: Parting 77 Scottsdale 1/2 ton 4x4
 

pics

Re: Parting 77 Scottsdale 1/2 ton 4x4
 

Interested in cargo light to 14222. What is the condition of the chrome, any pitting? Is it possble to get a small piece of wire to splice into all screws and gasket.

Re: Parting 77 Scottsdale 1/2 ton 4x4
 

Liddy71...They are rusty

madcow75...I will pull in next couple of days and verify condition for you.
Thanks,
Ray

Re: Parting 77 Scottsdale 1/2 ton 4x4
 

How about that t case shifter boot?

Re: Parting 77 Scottsdale 1/2 ton 4x4
 

It looks good, but I will pull and check condition. What zip or postal code is it going to? BOOT SOLD
Thanks,
Ray

Re: Parting 77 Scottsdale 1/2 ton 4x4
 

will the front inner wheel wells fit a standard 78 c15?

Re: Parting 77 Scottsdale 1/2 ton 4x4
 

06096, mostly interested in the plate with the gear indicator but if the boot itself is still good even better.

Re: Parting 77 Scottsdale 1/2 ton 4x4
 

Just curious, what is that in the left corner of the dash where the a/c vent would go if it were a a/c truck?

Re: Parting 77 Scottsdale 1/2 ton 4x4
 

Yes, but these ones are rusty. I will be parting another truck soon and the inners are probably good.
Thanks,
Ray

Re: Parting 77 Scottsdale 1/2 ton 4x4
 

Its an naftermarket wiper delay.

Re: Parting 77 Scottsdale 1/2 ton 4x4
 

cool..just let me know

Re: Parting 77 Scottsdale 1/2 ton 4x4
 

I see the vr4 weight dist hitch. Does this truck have the original hitch still on it? I need one for my 76 big ten.

Re: Parting 77 Scottsdale 1/2 ton 4x4
 

dang ray you are going to drive me broke ahaha. how much for left front wing window assembly??

Re: Parting 77 Scottsdale 1/2 ton 4x4
 

Curious about the side mounted spare. Any pix, thinking I might be able to use it in my 66 fleetside.
Pm me to remind me, I tend to forget.

Thanks,
Steve

Re: Parting 77 Scottsdale 1/2 ton 4x4
 

75gmc454...It looks to have a Reese receiver hitch, however, there is a rear sway bar that is missing a couple of pieces.
54Caddy...This vent window is junk...maybe the next truck has a good one.
qksilver...Sorry, this bed is not the original bed. The carrier is long gone.

I will start tearing into this tomorrow.
Thanks,
Ray

Re: Parting 77 Scottsdale 1/2 ton 4x4
 

How much for the heater assembly? The one under the dash holding the heater core. If it has no cracks or anything. Also, if it has the torx head screws holding all the light lenses in. Shipped to 01543. Thanks, Brian.

Re: Parting 77 Scottsdale 1/2 ton 4x4
 

Ray that bed appears to have at least one gas door on it... if they are in real good shape would you sell them and shippped to 08859

Re: Parting 77 Scottsdale 1/2 ton 4x4
 

liftlaw...I will pull soon and check condition. If good, $30 plus shipping. SOLD

Bob...I will take pics of the gas doors soon. SOLD

76stepside...The boot has a couple of rips. Boot, ring, indicator...$10 shipped. SOLD

madcow...I pulled the cargo light, switch, and harness. (it goes to the cab corner where it connects to the cab light harness) The chrome is not heavily pitted, but worn. The gasket to the lens fell apart and the rubber has wear. The lens looks good and it will need a bulb...pics: SOLD

Re: Parting 77 Scottsdale 1/2 ton 4x4
 

Boot/ring sounds good for 10 bucks, Just currious does that wiper delay setup work ? I might like to have that if it does.

Re: Parting 77 Scottsdale 1/2 ton 4x4
 

Cool I will take it. Where do I make payment. Where does the cargo bed light switch mount to from the factory. Can you send me a picture where it origanally was mounted. I would like to keep my truck looking as much as stock as I can. Dustin

Re: Parting 77 Scottsdale 1/2 ton 4x4
 

Thanks for looking Ray. I really dont know what the factory style hitch even looks like.. Just hoping this truck had one on it.
Im sure that the original chrome rear bumper and brackets are gone too then. That is what happened to my big ten. Someone got rid of all of that stuff and put a reese hitch on it and a step bumper.

Re: Parting 77 Scottsdale 1/2 ton 4x4
 

sounds good to me. Let me know. Thanks, Brian