72 rear frame/bumper help
2 Attachment(s)
Hey folks,
I have a 72 Blazer that is almost back in one piece and I need a little help figuring out how to remedy some PO handiwork. Looks like a different rear bumper was fitted on at some point and I’m not sure what it’s supposed to look like back there (no rear bumper when I bought it). The ends look to be cut off and brackets were “welded” on along with a trailer hitch which is also bolted and welded in. What would you recommend I do to fix this? I’m very much learning as I go. Thanks! |
Re: 72 rear frame/bumper help
1 Attachment(s)
Attachment 1905026
This is a 72 Blazer frame with a pickup bumper bolted to it. Just ignore the bumper and the two bolts. What you will see is an un-cut rear frame with the end tab bent out. If that tab was @ 90 degrees to the frame it would be correct. I just have to bend it back. You can see the rear frame body mount hole as reference. Hope that helps. Jeff |
All times are GMT -4. The time now is 10:27 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com