|
my project
5 Attachment(s)
I finally dove in and pulled out the old 350 which leaked from everywhere, and had a cracked block. Didn't know that till I pulled it out. So far I have redone the suspension. Put CCP 2.5 inch drop spindles, upper, and lower control arms. New rotors and calipers. New inner and out tie rods. New pitman arm, and idler arm. Just pulled all the dash components so I can start putting in my painless performance wiring harness. Then I'll be able to finally put in my Chevrolet Performance 350/ 330 hp crate motor.
|
Re: my project
1 Attachment(s)
my engine
|
Re: my project
What is that seat out of?
|
Re: my project
Nice project.
|
| All times are GMT -4. The time now is 05:45 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com