Hold down retainer for Speedo Bullet
Well my 15 minute project to replace the leaking speedo bullet has turned in to a more in depth job. The bolt for the hold down retainer broke off in the housing. Now I have to figure out how to extract the broken bolt.
First, anyone know what size bolt to replace the broken bolt with? Second, any MacGyver tricks for closing off the speedo bullet hole until I can get the broken bolt out and replaced? |
Re: Hold down retainer for Speedo Bullet
1 Attachment(s)
Not sure what size youd need but you could check parts store , or lowes or similar for one of these to plug the hole off..
Was the old bolt already broke..? Or did you break it trying to remove it... Getting it out may be simple or could turn night mare..drilling the center of the broke bolt and using a ease out may remove it...if its cross threaded itll be very difficult.. |
Re: Hold down retainer for Speedo Bullet
What transmission is this ?
If its an auto it would be quicker to remove the extension housing and replace it...if you do, replace the output bush and seal.... :chevy::chevy::chevy: |
Re: Hold down retainer for Speedo Bullet
Quote:
|
Re: Hold down retainer for Speedo Bullet
Quote:
I'll start looking for one those plugs. Probably better than buying my wife a bottle of wine with a rubber cork. |
Re: Hold down retainer for Speedo Bullet
Use the bullet!
It fits perfectly already. Wrap the tailshaft with duct tape to keep it in place and keep any metal filings out while you drill and use a left hand extractor to remove the stub. |
Re: Hold down retainer for Speedo Bullet
^^^^ Even better ^^^^^
|
Re: Hold down retainer for Speedo Bullet
Quote:
|
All times are GMT -4. The time now is 02:36 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com