New stock Front Leaf Picture?
Does anyone have a picture of a new(er) set of front leaf spring installed on a 55-59 truck?
I am looking at my truck and trying to figure out what i want to do in regards to the suspension this winter and thought i might install lowering springs. Best i can purchase is 3" lowering in the front. I wanted to look at a pic to compare to my current set to see how much it is actually going to make a difference. Not sure how much mine have already sagged with age. If mine have sagged 1" in last 60 years then with the 3" lowering springs i would really only get about 2" drop. |
Re: New stock Front Leaf Picture?
1 Attachment(s)
You're math is correct in that if it's down an inch now, a new lowered spring pack would only be 2" lower.
Check Kijiji for an ad in Ontario for a 3" lowering I beam. He seems to have them figured out for sure. This option will give you another 3" drop with your existing springs and all your factory bits bolt on. I have a 59 that has stock suspension so if you want some specific pictures, I can help out. |
Re: New stock Front Leaf Picture?
1 Attachment(s)
Thank you. Is it possible you could post a picture similar to this one?
As you can see there is little to no arch on these springs. Thanks again, appreciated. Attachment 1827694 Quote:
|
Re: New stock Front Leaf Picture?
1 Attachment(s)
Passenger side. Hope this helps.
|
Re: New stock Front Leaf Picture?
Yes that does help. If i had to guess i would say we have about 3/4"-1" difference.
|
Re: New stock Front Leaf Picture?
Quote:
|
I measured both sides. I have 3 3/4”. Bottome side of frame to top of leaf pack. So I have a difference of 1 1/4”.
A three inch drop spring will only give me a difference of 1 3/4” lower. Quote:
|
Re: New stock Front Leaf Picture?
Unless you buy the 3" drop spindle from Captain Hairless.
|
Re: New stock Front Leaf Picture?
Here's the Kijiji ad.
https://www.kijiji.ca/v-other-auto-p...ationFlag=true |
Re: New stock Front Leaf Picture?
1 Attachment(s)
My old springs we're pretty flat too, so I did a 3" drop axel, new King pins, tie rods and drag link. Pulled 4 leaves out of the rear and added drop shackles.
|
Re: New stock Front Leaf Picture?
Did you have to modify anything when installing the three inch drop axle? Did you replace the front leaf springs at the same time?
Quote:
|
Re: New stock Front Leaf Picture?
2 Attachment(s)
Quote:
|
Re: New stock Front Leaf Picture?
I replaced u bolts and added 4 degree shims per Sid's instructions.
|
All times are GMT -4. The time now is 06:00 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com