1960 Differential Cover
 

Hello Forum Members,
I have a basic stock half ton 1960 Chevy C10 Fleetside. It has a 235 motor and a 3 on the tree with over drive transmission and the stock six lug rear end. I believe it to be an ho33?
The question I have is does anyone make an Aluminum differential cover for this rear end? It is a 10 bolt but Summit told me they don't carry anything for this type of rear end and according to them no one makes any cover for it. Jeg's told me they had a cover for it but when I looked up that number it did not list my year truck.
So if anyone knows a cover that would fit please let me know, I am just going for a little bling. If there isn't one available, I will just clean and detail my stock one.

Thank You,

Snafu

Re: 1960 Differential Cover
 

I have never seen any sort of aftermarket chrome or aluminum cover for the Eaton HO32/33 differential.

Re: 1960 Differential Cover
 

Thank you Captainfab for the info. Is there something unusual about these rear ends or are they just not popular enough?

Thanks,

Snafu

Re: 1960 Differential Cover
 

They are just not used much these days. It has been 57 years since they were used. There is little to no aftermarket support for them. Personally I would just switch over to a truck 12 bolt. Wider gear selection and good aftermarket support.

Re: 1960 Differential Cover
 

Nitro gear and axle have one. they say same as toyoda fj40 9.5 rear. also fits gm 55-62

Re: 1960 Differential Cover
 

heres a pic. does it fit? I never bought one, their site says yes.

Re: 1960 Differential Cover
 

did you find anyone else beside these folks? Pretty expensive.

Re: 1960 Differential Cover
 

What about having the stock one chromed?

Re: 1960 Differential Cover
 

I thought the same but it's pricey too. Im going to take mine off and spray it with silver hammertone.