Good News!!!
It RUNSSSS
as some of you know I have been doing a engine rebuild the last week. here are some specs 87 TBI block 70~sbc 400 heads Comp cams Mutha Thumpr cam Kit Flat top pistons 650 edelbrock carb long tubes 2200 stall Movie With open shorties Movie with long tubes and mufflers Now I had a few questions, idle is at about 750 and when I put into drive or while driving and come to a stop it wants to die. I don't have power brakes or any accessories. Is the timing off? Thanks and enjoy :metal::metal: |
Re: Good News!!!
congratulations on getting it going
|
Re: Good News!!!
Sounds Like a chopy Cam :metal: if you have a beefy cam that could be the reason why it wants to die when you come to a stop.Don't know but that is what I experianced in my 71 I could be wrong and yours might be a different problem Truck Sounds good though..
|
Re: Good News!!!
Congrats on stat-up!!! With a big cam 750 may be too low in park/neutral. Have you tried turning it up 100 or so? fwiw...650 in drive is what I like to start at.
|
Re: Good News!!!
Quote:
|
Re: Good News!!!
Bobby it sounds good,,,,
Congrats on getting it going. |
Re: Good News!!!
Quote:
|
Re: Good News!!!
any luck gettin it dialed-in?
|
Re: Good News!!!
On a cam like that youll need to bump up the idle to about 900-1000rpm. Now as far as timing I always set mine by ear. Advance it till you hear it ping under a load then back it off till it stops and its always right on the money then.
|
Re: Good News!!!
Quote:
ahhh ok cool, i havent really messed with it because i have not had the time. but hopefully this weekend i will be able to dial it in. thanks for the help |
All times are GMT -4. The time now is 12:16 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com