Aftermarket Header installation problems
Hi
I am in the midst of restoring my grandfathers pick up. I left the six (250) in for the sake of memories. I wanted a little more out of it so in addition to an overhaul, bigger cam, offy intake, and Holley 390, I installed a set of headers. The problem is that the original fasteners don't fit with the aftermarket headers and intake. I used large washers and bolts instead and still the headers pull free and have made a nasty spot on my new paint job. How do some of ya'll have your headers and intakes fastened? Thanks a bunch! Will Hill |
Re: Aftermarket Header installation problems
Welcome to the site. you will need to get header bolts preferably with the lock ring to hold in place. Standard bolts will vibrate lose.
|
Re: Aftermarket Header installation problems
The headers should have come with proper bolts/hardware. BTW,there are no factory headers. All headers are aftermarket
|
Re: Aftermarket Header installation problems
Thank you both, I will run down to NAPA and see if I can get a set and give it a try. Thanks
Will Hill |
All times are GMT -4. The time now is 10:02 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com