Has anyone repinned the ECU connectors?
 

Ive been wanting to finish the wiring on my truck for a long time. The wiring was stock length and just taped with electrical tape so it doesnt look bad... but its unfinished. My goal is to have shorten the harness down so theres not excess wire hanging around. Basically neaten it up. Cutting and splicing wires is not an option.
I probally should insert picture here, but I dont have one at the moment... I will take one tomarrow and update the post. Ive found the connectors on the net and they are not expensive, just unsure of the size... wire size of .35 is in mm or in? my guess is MM. I figure it would be easier to mod that one connector instead of the ones on the engine. I just want to clean up the wiring and cross one more thing off of the bucket list.
So has anyone one the board done this themselves?
clint

Re: Has anyone repinned the ECU connectors?
 

0.35 wire is metric gage, equivalent to 22 gage English.

TR

Re: Has anyone repinned the ECU connectors?
 

I have done some repinning, its not hard, just take your time.