Parting out 1973 Chevrolet Cheyenne C20 3/4 ton
 

1973 Chevrolet Cheyenne C20 3/4 ton all or parts have title in hand

nice dent free front bumper, good chrome w/ brackets sold
radiator support sold
big block fan shroud sold
Big Block 4 core radiator sold
fenders, couple of dents in each sold
sliding rear window plastic latch is broken $50
white sun visors sold
inside pillar/ headliner trim $20 + shipping
door panels, arm rests and storage pockets $40 + shipping
14 bolt full floater, not sure of ratio or if posi or not sold
crack free windshield sold
Driver side door needs patch on lower outer corner sold
bed floor is rusty, but bed is useable sold
TH400 trans SOLD
nice black dash pad no cracks SOLD
non tilt steering column with key and wheel SOLD
Factory AM FM radio not sure if it works or not SOLD
grille sold
headlight rings sold
grill trim sold
engine not for sale

Re: Parting out 1973 Chevrolet Cheyenne C20 3/4 ton
 

Clear title whole truck minus engine and parts listed as already sold for $400

Re: Parting out 1973 Chevrolet Cheyenne C20 3/4 ton
 

Do you still have the fan shroud? If so, what is the diameter of the fan opening.
Thanks

Re: Parting out 1973 Chevrolet Cheyenne C20 3/4 ton
 

What condition are the door panels? I'm also interested in the front sway bar if it has one.

Re: Parting out 1973 Chevrolet Cheyenne C20 3/4 ton
 

Forgot to ask about the door molding. Decent condition?

Re: Parting out 1973 Chevrolet Cheyenne C20 3/4 ton
 

Do you have the trans crossmember?

Re: Parting out 1973 Chevrolet Cheyenne C20 3/4 ton
 

Correction : weatherstripping/seals

Re: Parting out 1973 Chevrolet Cheyenne C20 3/4 ton
 

Pm

Re: Parting out 1973 Chevrolet Cheyenne C20 3/4 ton
 

It does have te TH400 cross member. IT would be a while before I can pull it.$40 + shipping since it is a PITA to pull out.

Steve

Re: Parting out 1973 Chevrolet Cheyenne C20 3/4 ton
 

I will check the door panels. I am going to be using the sway bar on another truck.

Re: Parting out 1973 Chevrolet Cheyenne C20 3/4 ton
 

I will check tomorrow

Re: Parting out 1973 Chevrolet Cheyenne C20 3/4 ton
 

I do still have it. Iwill check it tomorrow.

Re: Parting out 1973 Chevrolet Cheyenne C20 3/4 ton
 

I'm interested in the cross member. Just to be sure this is the one that looks the same on both sides, not the goofy one that the crossmember goes under the driverside frame rail and the pass side sits inside the frame rail. Let me know when you get it out. thanks

Re: Parting out 1973 Chevrolet Cheyenne C20 3/4 ton
 

any pix of the bumper? shipping to 28387?

Thanks,
Steve

Re: Parting out 1973 Chevrolet Cheyenne C20 3/4 ton
 

I thought that I would let you know, the set up won't work for what I am doing. I went electric fan route. Thanks

Re: Parting out 1973 Chevrolet Cheyenne C20 3/4 ton
 

The shroud opening appears to be around 24". There are no cracks or breaks $40+ shipping.

Re: Parting out 1973 Chevrolet Cheyenne C20 3/4 ton
 

No shipping on bumper. Too expensive and too much hassle.

Re: Parting out 1973 Chevrolet Cheyenne C20 3/4 ton
 

Seals are toast

Re: Parting out 1973 Chevrolet Cheyenne C20 3/4 ton
 

Plastic is in good shape, not chalky, the wood grain is worn off driver side where previous owner rested his asrm. The passenger side is better, elastic is gone in both storage pockets, both arm rest pads are so so. $50 + shipping for pair

Re: Parting out 1973 Chevrolet Cheyenne C20 3/4 ton
 

The seat belts appear to be in decent shape. The plastic retractor covers are pretty well shot though. One release buckle on belt is missing the "GM" tag on the release button. Some rust on back of buckles. Woolite on the belt webbings and some WD40 and a scotchbrite pad on the chrome buckleswould do wonders for these. (These are lap belts only, not shoulder belts.) $40+ shipping for all belts mainly due to the fact that these are going to be a PITA to get out. You can have them for $20 if you pull them.

Re: Parting out 1973 Chevrolet Cheyenne C20 3/4 ton
 

I want the door panels if he passe
Posted via Mobile Device

Re: Parting out 1973 Chevrolet Cheyenne C20 3/4 ton
 

How are the Cheyenne 20 emblems on the front fenders?

Re: Parting out 1973 Chevrolet Cheyenne C20 3/4 ton
 

does it have the Cab Band?

Thanks,
Chris

Re: Parting out 1973 Chevrolet Cheyenne C20 3/4 ton
 

still interested in the trans crossmember.

Re: Parting out 1973 Chevrolet Cheyenne C20 3/4 ton
 

do u still have this if u do i would like the frame and the front with arm suspention if u still have it or just frame will work