Stock bumper height front and rear of 64 chev shortbed
My 64 stepside shortbed had the front and rear springs cut by the PO. It looks good, but cutting the pigtail off the bottom of the rear springs was not smart. They took some steel bars to bolt accross the bottom coil of the spring. The front ones are just too low. I can't find the factory dimensions for the stock bumper heights in my books or on this site. Can anyone give me a close dimension front and rear so I know where to start? I want to have a modest lowered stance, but also want the tires I put under it to fill in the wheelwells. Thanks, Roy
|
Re: Stock bumper height front and rear of 64 chev shortbed
I dont know what the stock height is but I do know 5 front 7 rear and 4 front 6 rear look good. I would recommend looking around at trucks to see what you like and see if you can find the drop specs for that. Good luck
|
Re: Stock bumper height front and rear of 64 chev shortbed
I can't believe that nobody knows the stock bumper height front and rear for my 64. I'm not looking for a precise measurment to the bumper bolts, just close would be OK. I'm just wanting a reference starting point. Thanks.
|
Re: Stock bumper height front and rear of 64 chev shortbed
1 Attachment(s)
Here you go...
|
Re: Stock bumper height front and rear of 64 chev shortbed
Thanks! That gives me a place to start from.
|
All times are GMT -4. The time now is 03:46 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com