re pinning VU4 manifold plug so hard lines can be symmetrical
 

Has anyone re pinned the VU4 manifold plug to change the location of the ports? I can't figure out how to get the plug apart and didnt want to damage it. I want to repin it so the 2 rear bag ports are on the 2 outside ports and the 2 front ports are the center ports. I'm not sure why Accuair has it wired so the front is the 2 left ports and the rear is the 2 right ports. Makes it hard to route the hardlines to the bags so they look good.

Any advice would be appreciated. I dont want to cut and solder any wires, I want it to be clean. I guess I can order a new plug so I dont need to worry about damaging the original.

Re: re pinning VU4 manifold plug so hard lines can be symmetrical
 

I am right there with ya. Just starting the work on mine. It's a Harley Davidson plug or aka deutsch plug.


http://youtu.be/f5QUJS_QOwM

Start around half way in this video. I felt stupid after it had me stumped for a bit.

Re: re pinning VU4 manifold plug so hard lines can be symmetrical
 

You're the man! Thanks, nice looking build