66 C10 Hood Repair - large shallow depression at rear of hood
 

66 C10 Hood Repair - large shallow depression at rear of hood

I'm doing rust and dent repair on the hood of my 66 C10. At the rear center area of the hood there is a large shallow depression. The picture below shows a straight edge laid on top of one of the ribs at the center of the hood.

a. I wanted to confirm that these ribs should be straight and flat, i.e. not have this depression.

b. Any suggestions on how to go about fixing this? Because it is such a large, unsupported area, it seems to want to "oil can" back to this position.

Thanks!

Re: 66 C10 Hood Repair - large shallow depression at rear of hood
 

Here's a thread I started with that same situation. Only one of my ribs dipped down so I'm possitive the area should be flat. My answer was I found a different hood :lol:, but there is some good advice in the replys.

http://67-72chevytrucks.com/vboard/s...d.php?t=783590

Re: 66 C10 Hood Repair - large shallow depression at rear of hood
 

You should Post this in the paint and body work along with more pictures

Re: 66 C10 Hood Repair - large shallow depression at rear of hood
 

Mack B --- thanks for the response and pointing me to those links, they were very helpful.

Regards,