Flexplate question
I’m putting in a 350 GM performance crate engine in a 72 K20 and it has a one piece rear main seal. Every flexplate at my local parts stores have a convex plexplate which puts the ring gear at 5/8” back of block compared to 15/16 for a two piece rear main flexplate. Should mention it’s a turbo 350 trans. I’m worried I’m going to be pulling the torque converter too far from the transmission. Surely others have put this common crate engine in? What are you doing for flexplate?
|
Re: Flexplate question
when I put in my crate motor, 1 piece RMS/external balance rear) I used this flexplate and I also have a TH350 in my 67 Camaro
https://www.summitracing.com/parts/p...make/chevrolet |
Re: Flexplate question
Thanks that’s the one I bought
|
Re: Flexplate question
I used the summit brand SFI rated flexplate on my L31-R vortec crate motor and it has worked perfectly.
|
Re: Flexplate question
Quote:
|
All times are GMT -4. The time now is 04:01 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com