[Putter]

Holler when you get is put in. I had to remove the cluster so I could trim the lip of the dash. (see 1st pic in this post) How I did mine was to simply cut a couple of relief slits in it and fold it out flat. I guess you can also use a cut-off or die grinder and remove it all together, but I wasn't near the compressor. I used a hack-saw (took like 4 strokes) and a pair of pliers.
I swear, if the switches were not so expensive, it would be easy to set these up and sell them as a kit, pre-wired and ready to plug in.