The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - third gen camaro hatch release relay location ?

TERRYP · 03-21-2002, 01:11 PM

No relay was on my '82. just a hot lead to the solenoid at the hatch. used the same solenoid to release my monte carlo trunk too, used no relay, set so was hot always, so can open trunk with no key in ignition.

------------------
Everett, Washington
57 3/4 rat, 235, 3spd
66 C-10 Panel, SWB. 350 from '68, 200R4 tranny, 3.55 rear ratio, restoring
68 C10 LWB 250 from '66 4spd, dump runner
82 Camaro, 305, THM-200-R4
84 Monte Carlo 305 TH350, land tuna
85 Tercel SW, snow runner

[This message has been edited by TERRYP (edited March 21, 2002).]

03-21-2002, 01:11 PM	#5
TERRYP GYRO GEARLOOSE Join Date: Jun 2000 Location: Nevada City, CAEverett, WA Posts: 361	No relay was on my '82. just a hot lead to the solenoid at the hatch. used the same solenoid to release my monte carlo trunk too, used no relay, set so was hot always, so can open trunk with no key in ignition. ------------------ Everett, Washington 57 3/4 rat, 235, 3spd 66 C-10 Panel, SWB. 350 from '68, 200R4 tranny, 3.55 rear ratio, restoring 68 C10 LWB 250 from '66 4spd, dump runner 82 Camaro, 305, THM-200-R4 84 Monte Carlo 305 TH350, land tuna 85 Tercel SW, snow runner [This message has been edited by TERRYP (edited March 21, 2002).] __________________ Nevada City, CA Everett, Washington 57 3/4 rat, 235, 3spd 66 C-10 Panel, SWB. 350 from '68, 200R4 tranny, 3.07 rear ratio, restoring 68 C10 LWB 350 4spd, 4.56 rear dump runner 82 Camaro, 305, THM-200-R4 84 Monte Carlo 305 TH350, land tuna 85 Tercel SW, snow runner DISGRACED OUTLAW MEMBER OF THE DRUM BRAKE CLUB