I was staring at mine today. I've wondered if most of a 3rd rocker could be made by cutting a cab rocker in half and work from both end to the middle. Even if the curved up portions don't work, most of the rust is usually down low, so, if the cross-section is the same shape, I'd just cut out the rusted section and weld in a patch rocker made by cutting the needed portion out of a cab rocker. Again, it all depends on whether the cab rocker and 3rd door rocker have the same cross section shape, height, width, etc. Obviously I have yet to look into to it closely.
__________________
'71 GMC K20 Suburban, '71 GMC K10 Suburban, '72 Chevy C10 CST Suburban, '72 Chevy K20 clunker pickup.
|