The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

jcfoote60 · 02-22-2006, 10:52 AM

Hey guys, quick question and opinions needed. VTBlazer put up a great post a while back on his work with Blazer bedsides which has me heading down the path of swapping bedsides on a couple of my rigs. So my question is this, since the bedsides primarily bolt on in so many locations down the side, in the front to the rockers, etc. do you really need to worry too much about alignment issues? It seems that once you bolt everything up, it is what it is and weld up a couple of spots in the back and front, you are set.............am I right or wrong??

I have learned the hard way about "assuming" too much, so need your expertise please.

JC

02-22-2006, 10:52 AM	#1
jcfoote60 Active Member Join Date: Jun 2005 Location: Idaho Posts: 263	Blazer bedside installation Hey guys, quick question and opinions needed. VTBlazer put up a great post a while back on his work with Blazer bedsides which has me heading down the path of swapping bedsides on a couple of my rigs. So my question is this, since the bedsides primarily bolt on in so many locations down the side, in the front to the rockers, etc. do you really need to worry too much about alignment issues? It seems that once you bolt everything up, it is what it is and weld up a couple of spots in the back and front, you are set.............am I right or wrong?? I have learned the hard way about "assuming" too much, so need your expertise please. JC